Sandblasting Room

ALP-KUM Sandblasting Rooms are the most ideal solutions for sandblasting large parts.

System sandblasting room (cabin-room), conveyor, spiral, elevator, separator, filter, dust trap system, piping system, control panel, lighting, personnel door, observation window, service ladder and platforms, grill, rails, walkway, material It consists of entrance and exit door, movable car, conveyor and portable pressure blasting machine.

The working principle of the system is as follows;

The materials are safely put on the car and taken into the cabin. The material is cleaned by spraying a mixture of compressed air and sand on the material in the room. The steel balls poured into the chamber come to the elevator with the conveyor and auger, and from the elevator to the separator. The steel ball is cleaned in the separator, and the cleaned steel balls are transferred back to the tank. Dust passes through a dry type mechanical filter. The cleaned air is given out by the fan. This completes the cleaning process.

ALP-SAND SANDBLASTING ROOM FEATURES:

-Our sandblasting rooms are steel construction. Sandwich Panel of 50 mm thickness is used as facade cladding (Sandwich Panel is preferred because it is an ideal choice for heat, sound and dust insulation.)

-The interior of the cabin is covered with rubber rubber. The rubber tire is special, wear-resistant.

- Our sandblasting rooms have a dust suction filter system that draws from the sides and from the bottom.

- Specially designed steel gratings are laid on the translational part of the floor so that the steel ball falling on the floor while sandblasting is carried out in the room can go to the separator. The sand particles falling down are collected in the sand chamber and conveyed to the helix with the help of a conveyor and from there to the elevator. It is transported from the elevator to the separator and becomes ready for use again. The conveyor system is designed with a special design that minimizes the foundation excavation. The fact that no excavation will be done for the cabin and the special designs of our company are among the biggest advantages offered to our valued customers. It is only necessary to dig a 130x130x80 cm elevator pit and a 40x40 cm Helozon pit for the sand particles from the conveyor system to the separator.

In products that fit inside the room, all doors are closed, providing abrasive and sound insulation.

- The sand coming to the elevator is carried up by the elevator buckets and goes to the separator from there.

-The cleaned ball is stored and transferred to the pressure blasting machine from there.

- The sand in the pressurized machine is sprayed onto the surface of the workpiece to be sanded with the help of the automatic control in the hands of the operator in the cabin.

-There is a signaling alarm in the cabin when the system is running.

-Steel granules, grit and silica sand can be used in the system. The operation of the system continues in this way.

SANDBLASTING EQUIPMENT USED IN THE SANDBLASTING ROOM, FEATURES:

1-Pressured Sand Boiler

2-Top Shutoff Valve

3-Pressure gauge (Manometer)

4-Sand Regulating Valve

5-Automatic Air Opening and Closing System

6-Special waterstop filter Regulator 10-16 Bar

7-Safety valve 10 Bar

8-Air gauge (Manometer)

9-Sandblasting hose 10 Bar

10-Compressor Air Hose Pressed 1” / 10 Bar

11-Sandblasting Mask and Protection Suit

Nozzle of 12-8 mm

13-It is a System Complete with Air Open and Close Trigger

QUALITY STANDARD:

1. Surface Cleaning: Sa2 - Sa2,5.

2. Surface Roughness: 15-50 micron quality.